Skip to content
Tuxedo CatSTUDIO
Menu

Getting Started

Review draft. This source page has not completed website editorial and release-specific verification.

  1. Add a Diagnostic Probe node from the Blueprint action menu under Diagnostic Director > Probes.
  2. Set a short Probe Label, connect the value to observe, and connect execution through the node.
  3. Run the Blueprint in PIE and open Tools > Director Suite > Runtime Inspectors > Diagnostic Director Runtime Inspector.
  4. Find the probe, check Watch to keep it in the watched set, and double-click its row to open the owning Blueprint at the exact node.
  5. Remove temporary probe nodes when troubleshooting is complete. The Inspector’s release audit lists all remaining project probes.

Probe values update automatically while Auto Refresh is on. Refresh requests an immediate update. Columns and watch selection are local presentation state; neither changes Blueprint behavior.